Rapid qualitative profiling and quantitative analysis of Juglandis Mandshuricae Cortex and seven flavonoids by ultra-high performance liquid chromatography–quadrupole/orbitrap high-resolution mass spectrometry

Juglandis Mandshuricae Cortex is the bark of Juglans mandshurica Maxim., which has been used as a folk medicine plant in China and India. In this study, an ultra-high performance liquid chromatography–quadrupole/orbitrap high-resolution mass spectrometry method was developed to clarify and quantify the chemical profiling of Juglandis Mandshuricae Cortex rapidly. A total of 113 compounds were characterized. Among them, seven flavonoids were simultaneously quantified in 15 min, including myricetin, myricetrin, taxifolin, kaempferol, quercetin, quercitrin, and naringenin. The method was validated for accuracy, precision, and the limits of detection and quantification. All calibration curves showed a good linear relationship (r > 0.9990) within test ranges. The intra- and inter-day relative standard deviations were less than 2.16%. Accuracy validation showed that the recovery was between 95.6 and 101.3% with relative standard deviation values below 2.85%. The validated method was successfully applied to determine the contents of seven flavones in Juglandis Mandshuricae Cortex from seven sources and the contents of these places were calculated respectively. This method provides a theoretical basis for further developing the medicinal value of Juglandis Mandshuricae Cortex.     

金属衬底在石墨烯化学气相沉积生长中的作用

以过渡金属为催化衬底的化学气相沉积法(Chemical Vapor Deposition，CVD)已经可以制备与机械剥离样品相媲美的石墨烯，是实现石墨烯工业应用的关键技术之一。原子尺度理论研究能够帮助我们深刻理解石墨烯生长机理，为实验现象提供合理的解释，并有可能成为将来实验设计的理论指导。本文从理论计算的角度，总结了各种金属衬底在石墨烯CVD生长过程中的各种作用与相应的机理，包括在催化碳源裂解、降低石墨烯成核密度等，催化加快石墨烯快速生长，修复石墨烯生长过程中产生的缺陷，控制外延生长石墨烯的晶格取向，以及在降温过程中石墨烯褶皱与金属表面台阶束的形成过程等。在本文最后，我们对当前石墨烯生长领域中亟需解决的理论问题进行了深入探讨与展望。     

The Preparation of Cu(II)- and Ag(I)-responsive Carbon Nanodots from the Right Amino-acid Carbon Source

Journal of Fluorescence - Carbon nanodots (CDs) have exhibited excellent sensing capability for various metal ions. However, it is difficult to determine the selectivity of CDs to metal ions. In...     

Investigation of Molecular Diffusion at Block Copolymer Thin Films Using Maximum Entropy Method-Based Fluorescence Correlation Spectroscopy and Single Molecule Tracking

Fluorescence correlation spectroscopy (FCS) has been widely used to investigate molecular diffusion behavior in various samples. The use of the maximum entropy method (MEM) for FCS data analysis provides a unique means to determine multiple distinct diffusion coefficients without a priori assumption of their number. Comparison of the MEM-based FCS method (MEM-FCS) with another method will reveal its utility and advantage as an analytical tool to investigate diffusion dynamics. Herein, we measured diffusion of fluorescent probes doped into nanostructured thin films using MEM-FCS, and validated the results with single molecule tracking (SMT) data. The efficacy of the MEM code employed was first demonstrated by analyzing simulated FCS data for systems incorporating one and two diffusion modes with broadly distributed diffusion coefficients. The MEM analysis accurately afforded the number of distinct diffusion modes and their mean diffusion coefficients. These results contrasted with those obtained by fitting the simulated data to conventional two-component and anomalous diffusion models, which yielded inaccurate estimates of the diffusion coefficients. Subsequently, the MEM analysis was applied to FCS data acquired from hydrophilic dye molecules incorporated into microphase-separated polystyrene-block-poly(ethylene oxide) (PS-b-PEO) thin films characterized under a water-saturated N₂ atmosphere. The MEM analysis revealed distinct fast and slow diffusion components attributable to molecules diffusing on the film surface and inside the film, respectively. SMT studies of the same materials yielded trajectories for mobile molecules that appear to follow the curved PEO microdomains. Diffusion coefficients obtained from the SMT data were consistent with those obtained for the slow diffusion component detected by MEM-FCS. These results highlight the utility of MEM-FCS and SMT for gaining complementary information on molecular diffusion processes in heterogeneous material systems.

Graphical Abstract

     

白云石制备似立方体状方解石型碳酸钙晶体及其机理研究

以轻烧白云石粉、氯化铵和二氧化碳为原料,在未使用晶型控制剂的情况下,通过蒸氨-沉钙过程制备出了似立方体状碳酸钙。研究了反应温度、溶液中钙离子浓度、通气速率、搅拌速度以及陈化时间对碳酸钙中方解石相含量以及晶体形貌的影响,并探索了沉钙反应的晶型控制机理。结果表明,在反应温度40 ℃、钙离子浓度0.05 mol/L、通碳速率100 mL/min、搅拌速度400 r/min和陈化时间2 h的条件下,制备出形貌规整、粒径分布均匀的似立方体状碳酸钙,平均粒径为5~10 μm。该研究为提升白云石的使用价值、生产高附加价值的碳酸钙产品,以及提高白云石资源的利用率提供理论基础。     

Quantitative Analysis of Al in Flour Products by Laser-Induced Breakdown Spectroscopy Combined with Partial Least Squares

Journal of Applied Spectroscopy - Based on partial least squares (PLS) analysis, the effects of different smoothing points and different preprocessing methods on the accuracy and precision of the...     

非富勒烯受体DA'D型稠环单元的结构修饰及电池性能研究

近年来,设计和合成高性能非富勒烯受体(NFAs)材料已经成为太阳能电池研究领域的前沿课题。基于DA'D型稠环结构的NFAs由于具有吸光系数高、能级和带隙可调、结构易于修饰、分子可高效合成、光电学性能优异等优点而受到了越来越广泛的关注。在短短7年的时间里,能量转换效率(PCE)从3%~4%提高到18%。2019年初邹应萍等报道了一个优秀的受体分子Y6,与PM6共混制备单结电池,获得了15.7%的能量转换效率。Y6类受体材料的中心给电子单元为DA'D型稠环结构,缺电子单元(A')通过氮原子与两个给电子单元(D)并联形成稠环结构,这有助于降低前线分子轨道能级并增强吸收,同时与氮相连的两个烷基链和位于噻吩并噻吩β位的两个侧链则有助于提高溶解度及调节结晶性。自Y6问世以来,人们对分子的结构剪裁进行了深入的研究,并报道了数十种新的结构。在这些新的受体中,DA'D部分的结构裁剪对提高器件效率和太阳能电池的性能起着至关重要的作用。本文对A'、D单元和侧链结构修饰的研究进展进行了综述。通过选择几组受体,对最近报道的分子进行分类,并将它们的光学、电化学、电学和光电性质与精确的结构修饰相关联,从而对结构-性能关系进行全面概述。     

LaNi0.5Co0.5O3催化剂对甲烷二氧化碳干重整反应在CO2渗透膜反应器中的影响

制备了混合导体膜反应器,通过电化学方法捕获CO2,并将其用于甲烷二氧化碳干重整反应中.采用XRD, SEM,TPR等技术系统研究了LaNi0.5Co0.5O3催化剂在膜反应器中对甲烷二氧化碳干重整反应的影响.结果表明:LaNi0.5Co0.5O3催化剂在甲烷干重整反应中能原位析出纳米金属Ni和Co,对反应起到了较好的催化作用,同时抑制了积碳.催化剂还具有良好的氧化还原性能,可以循环利用.     

Kinetics and isothermal adsorption of U(VI) in aqueous solution by nano-Ni0

Journal of Radioanalytical and Nuclear Chemistry - The nanoscale zero-valent nickel (nano-Ni0) was prepared by liquid-phase reduction method and characterized by BET, XPS, FT-IR and XRD and be used...     

The metabolites and biotransformation pathways in vivo after oral administration of ocotillol,RT5, and PF11

Ocotillol, pseudo-ginsenoside RT5 (RT₅), and pseudo-ginsenoside F₁₁ (PF₁₁) are ocotillol-type saponins that have the same aglycone structure but with different numbers of glucose at the C-6 position. In this study, the metabolites of ocotillol, RT₅, and PF₁₁ in rat plasma, stomach, intestine, urine, and feces after oral administration were investigated by ultra-performance liquid chromatography coupled with time-of-flight mass spectrometry. The results showed that RT₅ was easily biotransformed into metabolites in vivo, whereas PF₁₁ and RT₅ were difficult to be biotransformed. Hydrogenation, dehydrogenation, dehydration, deglycosylation, deoxygenation, hydration, phosphorylation, deoxidation, glucuronidation, and reactions combining amino acid were speculated to be involved in the biotransformation of ocotillol, RT₅, and PF₁₁. Based on the structural analysis of metabolites, it was deduced that hydrogenation, dehydration, deoxidation, and reactions combining amino acid occurred on the aglycone structure, whereas deglycosylation, hydration, and phosphorylation occurred on the glycosyl chain. Further, metabolites in plasma, urine, feces, and tissues were different: First, glucuronidation products were found in urine, stomach, intestine, and feces, but not in plasma. Second, the ocotillol prototype was not identified in urine samples. Third, the RT₅ prototype was found in stomach, intestine, feces, and urine, but not in plasma.